Jump directly to page content

Hünnebeck in the UK | Loading platform

Loading Platform

For safe material transport on the construction site

The loading platform offers a safe parking area of around 10 m2, over which loads can be loads can be transported in and out of the building at ground level.

Product advantages

Worker using FalPro V1
 

Work productively

  • Anchoring to the building is not necessary - FalPro V1 is immediately ready for use.
  • No impact on structural analysis
  • The device may be relocated and transported by just one person using suitable and permitted means of transport.
  • The attachment of approved loading straps or 4-rod harness for relocation with a crane is made possible by the four foldable lashing rings on the base plate.
  • On flat surfaces with an angle less than 5°, the design of the device allows the operator to individually determine the position of their anchor.
Using FalPro V1 on high building
 

Work safely

  • FalPro is used to secure a person against falling; can also be used for the installation of PROTECTO fall protection system
  • Overhead anchor point prevents from tripping hazards
  • In its default position, the anchor point is 7.7 feet / 2.35 m above the installation surface. Therefore, also can also be used within the floors
  • To increase safety, the safety device is activated even before the maximum load is exceeded. This independently results in a slight shift of the anchor whilst simultaneously securing the anchor against rotation.
  • Base plate equipped with anti-slip mats

Technical data

Device weight

Min. 1113.3 lbs / 505 kg

Anchor point height in the default state

7.7 feet / 2.35 m

Anchor point height in safety position

3.8 feet / 1.15 m

Lowest base diameter

6.8 feet / 2.08 m

Largest base diameter

7.4 feet / 2.25 m

Anti-slip segments

12 pieces

Sliding friction

μ 0.65 µ +/- 5 %

Pressure force of the safety unit

Min. 29050 N Max. 30327 N

Triggering time of safety unit

Min 1.5 sec. Max 2.0 sec.

Corrosion protection primer, base Epoxy resin

Min. 60µm

Topcoat RAL (standard)

3001 signal red 9003 signal white

Lashing rings

4 pieces 4000 N each

Trigger force of the safety device

1.1 – 1.5 kN Exceeding

Hydraulic oil

HLP-46

Related products

Question not answered yet? We are here to help!